Skip to content

Mounting guidelines for ID-engine XE

Dimensions

Drawing ID-engine XE with dimensions

Dimensions in mm. Tolerance +/- 0.5 mm. Drawing not to scale.

Connect

Here's how you connect an ID-engine XE reader to a network and power supply.

If you want to use static IP addresses, configure them before installating the readers.

Connect to network

The connector box of the IDE XE reader provides 2 RJ-45 connectors for Ethernet connections: Both ports are connected to the reader device via an internal layer-2 switch. With this box, you can easily integrate the reader by looping it into an existing network connection.

Please connect the ports as follows:

Connector box of BALTEH ID-engine XE with Ethernet and power connections

There are 2 connection modes:

Normal operation mode

Connect the Network port; the Device port is optional and can be used to connect a PC or another network device.

In this mode, the reader operates with the activated network addressing mechanisms, protocols, and security features.

Maintenance mode

Connect only the Device port, e.g. to a maintenance laptop; the Network port is open.

This mode is recommended for troubleshooting or development. It enables all supported network addressing mechanisms and protocols and gives you unauthenticated access. Thus, you can circumvent the accessibility restrictions of normal operation (learn more).

Connect to power supply

You can power ID-engine XE in 2 ways:

  • Wall power supply: A wall power supply cable (5V, 1A) comes with the reader. Connect it to the DC connector in the back of the connector box.
  • Power over Ethernet (PoE): The Network port (see image above) provides PoE capabilities. The reader supports common-mode data pair (Mode A) and spare-pair (Mode B) power transmission as well.

    Use an IEEE 802.3af-compliant switch/injector

    A non-compliant switch/injector can irreparably damage the reader.

If power supply is OK, the LED turns orange and you'll hear a short beep.

In case of different signals, please see our troubleshooting guide.

Mounting

Use velcro tape or double-sided adhesive tape to fix the reader in the desired position.